Filter
Top Products
SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
8-46 XEROX DOCUPRINT 180 LPS PDL REFERENCE
IMAGE
In batch mode, this OVERPRINT = parameter defines new imaging
parameters for subsequent graphics. In all other modes, it defines
imaging parameters for the named graphic.
Syntax IMAGE =
option(s)
Options Table 8-31 lists the parameter option(s) and definition(s).
Table 8-35. IMAGE parameter option(s) and definition(s)
Option(s) Definition(s)
(
img-name
,
vpos
{UN | CM | IN | DOTS}
,
hpos
{UN | CM | IN | DOTS}
,[,T][,H][,
n
[/
d
]])
This option has the following components:
•
img-name
The name of an IMG file or the name on the DJDE
sentinel record, such as GRAPHIC=name) of a page
interleaved graphic immediately following the current
page. The name parameter may be omitted in batch
mode; however, the comma before vpos must be coded,
since it is a positional parameter.
•
vpos
Specifies the vertical position of the top edge of the
graphic as an offset relative to 0,0 on the current physical
page (the position that would be specified by a PDE
BEGIN of 0,0). This parameter is specified as a decimal
number with up to three digits to the right of the decimal
point and may be in DOTS, centimeter (CM), inches (IN),
or user-defined units (UN). If UN is specified, the user-
defined positioning unit must previously be defined by the
UNITS parameter of the OUTPUT command of the current
JDE or JDL (refer to the chapter "Using logical
processing"). If no units are specified, inches are
assumed.
•
hpos
Specifies the horizontal position of the left edge of the
graphic as an offset, relative to 0,0 on the current physical
page. The form of the specification is the same as for
vpos
.
• T
Specifies that the referenced graphic is page interleaved
and follows the current page data in the input stream.
• H
Specifies that the same graphic is to be held and imaged
without further callouts, at the same position and with the
same scale factor on all subsequent pages until changed
by a DJDE CANCEL or ALTER.
•
n
/
d
Specifies the reference scale factor. Refer to the “Scaling”
section in your
DocuPrint 180 LPS Operations Reference
for more information.