Filter
Top Products
PRINT DESCRIPTION LANGUAGE (PDL)
XEROX DOCUPRINT 180 LPS PDL REFERENCE 2-17
catalog which, in turn, specifies EBCDIC in the VOLUME command
CODE parameter.
Figure 2-6. Hierarchy of replacement
Non-JDL hierarchy — START command
The next level of command replacement above the JOB or JDE
command (as illustrated in figure 2-6) is the START command.
Values specified in the START parameter override those in the job
command level. When the COPIES parameter is specified in the
START command, it overrides a DJDE value for COPIES from the
input data stream.
START command
The START command is used to initiate printing of the application
you have created. The options shown below vary depending on the
input source and the output destination. The offline and online
START command formats are as follows:
Offline START [[
jde
] [,[
jdl
] [,[S | M] [,[
copies
] [,[REPORTS:r
1
,r
2
,...]
[,,TD
n
] | [DISC:
file.ext
]]]]]]
Online START [[
jde
] [,[
jdl
] [,,[
copies
] [,FORM=
form
]]]]
Restrictions Note the following restrictions:
• The START command parameters are positional and must be
separated by commas. You must enter a comma to replace a
parameter that is not specified. The options you specify in the
START command override those specified in the job descriptor
library.
Highest order DJDE RECORDS*
↓
TAPE LABEL
↓
START COMMAND*
↓
JOB/JDE COMMAND LEVEL
↓ Options introduced at
CATALOG COMMAND LEVEL higher level override
↓ those at lower level
SYSTEM/JDL COMMAND LEVEL
↓
Lowest order OSS DEFAUTS
*One exception to this hierarchy is that the COPIES parameter in the START
command overrides COPIES DJDE from the input data stream