Filter
Top Products
SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
8-24 XEROX DOCUPRINT 180 LPS PDL REFERENCE
BATCH
This parameter is supported for online batch mode jobs only. It
permits normal processing of online banner pages for batch mode
jobs by delimiting the batch mode graphic data. It must be used
precisely to mark the beginning and ending of online batch mode
data. The first graphic (or IMAGE DJDE) must be preceded
immediately by a BATCH=START DJDE, and the last graphic must
be followed immediately by a BATCH=END DJDE. This parameter,
when specified, must be the only parameter in the DJDE packet.
Syntax BATCH =
option(s)
Options Table 8-12 lists the parameter option(s) and definition(s).
BEGIN
This parameter specifies the location of the starting print line of a
logical page for graphics. The vpos parameter specifies the vertical
position of the first character of the first print line on the logical page.
It may be specified in inches (IN) or centimeters (CM). The default is
inches.
Syntax BEGIN =
option(s)
Options Table 8-13 lists the parameter option(s) and definition(s).
In specifying the location of the beginning of a print line on the logical
page, measurement is performed by viewing the page in the mode
(landscape or portrait) in which it is to be printed. There may be more
than one logical page per physical page; these are defined by the use
of multiple BEGIN parameters. If no BEGIN parameter is specified,
then the default is FMT1.
Table 8-15. BATCH parameter option(s) and definition(s)
Option(s) Definition(s)
START Marks the beginning of online batch mode data.
END Marks the end of online batch mode data.
Table 8-16. BEGIN parameter option(s) and definition(s)
Option(s) Definition(s)
vpos
Specifies a decimal number with up to three digits to
the right of the decimal point, for example, 0.563IN
and 2.35CM are all legal specifications.
hpos
Specifies the horizontal position of the first character
of the first print line on the logical page (in IN or CM
as for vpos). All specifications are rounded to the
nearest dot (1/300 of an inch) for positioning of the
logical page.