Filter
Top Products
203
Specifications
Ribbon Specifications
9/6/07 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-004 Rev. A
Ribbon Specifications
Refer to the following tables for ribbon specifications.
110XiIIIPlus and R110Xi
Note • Consider the following when using ribbon:
• Match the ribbon to the label width and printhead width that you are using. The ribbon
should be at least as wide as the labels to protect the printhead from excessive wear.
• Ribbon must be wound with the coated side out.
Ribbon Specifications
110XiIIIPlus/R110Xi
200 dpi
110XiIIIPlus/R110Xi
300 dpi
110XiIIIPlus
600 dpi
Printhead resolution 203 dots/inch
(8 dots/mm)
300 dots/inch
(12 dots/mm)
600 dots/inch
(24 dots/mm)
Ribbon width Minimum 0.79 in. (20 mm)* 0.79 in. (20 mm) 0.79 in. (20 mm)
Ribbon width Maximum
4.33 in. (110 mm) 4.33 in. (110 mm) 3.40 in. (87 mm)
Standard length with 2:1
label to ribbon ratio
984 ft (300 m) 984 ft (300 m) 984 ft (300 m)
Standard length with 3:1
label to ribbon ratio
1476 ft (450 m) 1476 ft (450 m) 1476 ft (450 m)
Ribbon core inside
diameter
1.0 in. (25.4 mm) 1.0 in. (25.4 mm) 1.0 in. (25.4 mm)
Maximum ribbon roll
outside diameter
3.2 in. (81.3 mm) 3.2 in. (81.3 mm) 3.2 in. (81.3 mm)
* For RFID labels, the minimum ribbon width is determined by the minimum label width for the transponder being used.