Filter
Top Products
Configuration
Control Panel Parameters
88
13383L-004 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 9/6/07
Set Protocol
Protocol is a type of error checking system. Depending on the selection, an
indicator may be sent from the printer to the host computer signifying that
data has been received. Select the protocol that is requested by the host
computer. Further details on protocol can be found in the ZPL II
Programming Guide.
Default: NONE
Selections: NONE, ZEBRA, ACK_NAK
Note • ZEBRA is the same as ACK_NAK, except that ZEBRA
response messages are sequenced. If
ZEBRA is selected, the printer
must use
DTR/DSR for host handshake protocol.
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Network ID
Network ID is used to assign a unique number to a printer. This gives the
host computer the means to address a specific printer. This does not affect
TCP/IP or IPX networks.
Default: 000
Range: 000 to 999
To change the value shown:
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
Set Communications Mode
The communication diagnostics mode is a troubleshooting tool for
checking the interconnection between the printer and the host computer.
For more information, see Communications Diagnostics Test on page 171.
Default: NORMAL MODE
Selections: NORMAL MODE, DIAGNOSTICS
To select communication diagnostics mode:
1. Press the left or right oval to toggle between the options.
Table 10 • Printer Parameters (Sheet 17 of 27)
Parameter
Action/Explanation
PROTOCOL
- NONE +
NETWORK ID
- 000 +
COMMUNICATIONS
- NORMAL MODE +