Filter
Top Products
Configuration
Control Panel Parameters
90
13383L-004 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 9/6/07
Select ZPL Mode
The printer remains in the selected mode until it is changed by this
parameter or by using a ZPL/ZPL II command. The printer accepts label
formats written in either ZPL or ZPL II, eliminating the need to rewrite any
ZPL formats that already exist. See the ZPL II Programming Guide for
more information on the differences between ZPL and ZPL II.
Default: ZPL II
Selections: ZPL II, ZPL
To change the value shown:
1. Press the left or right oval to toggle between the options.
Select Media Power-Up Option
This parameter sets the action of the media when you turn on the printer.
Default: CALIBRATION
Selections: FEED, CALIBRATION, LENGTH, SHORT CAL, and NO
MOTION
• Feed—feeds the labels to the first registration point.
• Calibration—determines the length of the label and adjusts the
sensor settings.
• Length—In continuous mode, feeds the last stored label length. In
noncontinuous mode, calibrates based on the maximum label length
setting (see Set Maximum Label Length on page 76).
• Short Cal—calibrates label length using the current sensor settings.
• No Motion—the media does not move. You must press
FEED to
cause the printer to resynch to the start of the next label.
To change the value shown:
1. Press the left or right oval to scroll through the options.
Table 10 • Printer Parameters (Sheet 19 of 27)
Parameter
Action/Explanation
ZPL MODE
- ZPL II +
MEDIA POWER UP
- CALIBRATION+