Zebra Technologies 7030 Printer User Manual


 
Programming
System Related Commands
54
P1003636-002 TTP 7030™ Technical Manual 10/05/2009
This command is used to load a font to the printer flash PROM. The font is placed in the first
free address position in the order of load sequence.
A Zebra font-file consists of a header containing data describing the font as well as data for
each individual character in the font.
Fonts can be designed with the font editor and loaded or deleted with the software available for
free on the Zebra web site. The font loading and deleting commands described here should
only be used if you do not work in the Windows environment.
For complete specification of the font format, see Font Loading on page 64.
Erases all fonts stored in the flash PROM.
Erases fonts number 4–7. Fonts 0–3 are not affected by this command.
The operation is complete when the printer resets automatically and activates the presenter
motor temporarily. Takes approximately 4 seconds.
This command resets the parameters of the printer to factory default.
Temporarily sets all parameters to predefined values that are stored in the printer. To keep the
values as default, store them in the flash PROM with command <ESC>&<4>.
Unless you save the parameters, a reset command or power OFF/ON will return the
parameters to the settings stored in the flash PROM.
ESC & 0
Load Font
1B 26 00 hex
27 38 0 decimal
Note • The available font memory is printed on the self-test printout. A maximum of 8 fonts
can be addressed. Exceeding any of these limits will cause this command to fail.
ESC & C
Erase all Fonts
1B 26 43 Hex
27 38 67 decimal
Note • This command is only executed if at least one font has been loaded.
ESC & D
Erase Fonts 4 to 7
1B 26 44 Hex
27 38 68 Decimal
ESC & F
Reset Parameter Profile
1B 26 46 Hex
27 38 70 decimal