Filter
Top Products
11
Product Presentation
Indicators
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Indicators
Status Indicator
The status indicator (see Figure 1, Printer Exterior, Rear View , on page 9) has several
functions:
Error-codes are reset:
• When the conditions causing them are removed.
• When the printer is turned off/on.
• When the blue printhead release arm is lifted and then lowered.
Control Board Indicators
The control board has two power indicators behind the power connector:
• Green indicator constantly ON: 24 V present
• Red indicator constantly ON: 5 V OK (generated on control board)
ON constantly Indicates that the printer is operational.
Flashes, pauses, flashes Indicates warnings of non-severe error. The number of flashes
reflects the warning-code:
• 2 flashes: Paper low
Note • This signaling is disabled by default. It can be
disabled/enabled by setting parameter P52.
• 3 flashes: Weekend low
Warning-codes are reset automatically when the condition
causing them are removed.
Flashes rapidly Indicates severe error. Hold down the Feed button and the
number of flashes will reflect the error-code.
• 1 — Presenter jam, paper cannot be ejected / retracted
• 2 — Cutter cannot return to home position
• 3 — Out of paper
• 4 — Printhead lifted
• 5 — Paper wrapped around platen (under head)
• 6 — Temp error >60°C
• 7 — Presenter jam, motor cannot rotate
• Fast flashes — Checksum error, firmware
• Steady light — Wrong firmware type