Zebra Technologies 7030 Printer User Manual


 
69
Programming
Default Parameter Settings
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Default Parameter Settings
Some of the printer settings can be stored in the flash PROM so that they will be used also
after power OFF.
The stored parameter settings are printed out on the self-test printout.
The number in front of the function is the parameter number (n) used when setting the
parameter with the command <ESC>&P<n><v>.
You can use the parameter settings pretty much like normal commands. Either send the
parameter values with each printout, or set them up once and then send <ESC>&<4> to store
all settings in the flash PROM.
You can always return to factory default settings by sending <ESC>&<F>, and then storing
those settings with <ESC>&<4>
.
Note • The parameters can be locked so that no changes are possible. Check parameter 53 on
the self-test printout to find out.
Note • If you try to set a parameter to an invalid value, the parameter will be set to the
nearest valid value below.