Page Setup
Parameters Used
92
P1003636-002 TTP 7030™ Technical Manual 10/05/2009
Document
At the End Of the Document
Example • The commands are used together in the following way:
The following examples are not made for a specific programming language or editor, but can
be implemented with the tools of your choice. The data sent to the printer are marked with
“Send”.
When setting up the printer:
Send <ESC>&P<35><1> Enables black mark sync
Send
<ESC>&P<37><4> Sets distance between two black marks
Send
<ESC>&P<38><0> n37=4d and n38=0d gives 128 mm
Send
<ESC>&P<39><80> Sets max Blackmark to 80 x 0.125 = 10mm
Send
<ESC>&P<40><24> Sets max Blackmark to 24 x 0.125 = 3 mm
Send
<ESC>&P<41><0>
Send<ESC>&P<42><200> Sets Blackmark offset to 200 x 0.125 = 25mm
Send
<ESC>&P<43><0>
Send<ESC>&P<44><0> Sets Blackmark top margin to 0mm
Send
<ESC>&<4> Stores the above parameters as default parameters.
The above sets up and stores the parameters in the flash prom of the printer, so this need only
be sent once to the printer when setting it up for Blackmark sync.
Send the text and graphics
Send <ESC>Z Feeds the printout to the next black-mark + the additional feed
specified by the ESC x command.
Send <RS> Cuts and ejects the printout.