Zebra Technologies 7030 Printer User Manual


 
75
Default Parameter Settings
Parallel Port Setup
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Parallel Port Setup
Pins 12 and 15 on the parallel port signals paper out and error. However, in an unattended
kiosk you may not want this because it causes the host computer to stop communicating, and
the operating system may display a banner on the kiosk screen.
By disabling the hardware signals, the kiosk software can for example use status commands to
find out paper level and alert appropriate personnel when the level is low, then close the kiosk
when paper is out.
5
0Default
Disable Parallel Port Signaling
0 Min
1Max
<ESC>&P<5><0> No, paper out and error signals are not disabled
<ESC>&P<5><1> Yes, paper out and error signals are disabled
Note • When enabled, the hardware signal on pin 12 and 15 will block all communication
until the error is corrected. This means that it will be impossible to ask for status.