87
Page Setup
Aligning Preprint And Thermal Print
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Aligning Preprint And Thermal Print
The printer can synchronize the cutting of the printout with black-marks printed on the back of
the paper. Use this function when you have preprint on the media and you don't want a cut in
the middle of that preprint, or text printed on top of the preprint.
The sensor used to detect the black-marks is the same sensor as used for paper end detection. It
is positioned 9 mm from the edge of the paper on the side of the blue release arm, and 25 mm
behind the cutter (as seen from the presenter [output] side of the printer). The sensor accuracy
is about ±0.5 mm so avoid designing printouts with too high demands for synchronization.
Figure 22 • Recommended black mark size and position
The sensor triggers on the black-to-white transition of the black-mark, which is when the black
print ends (trailing edge).
Cut line
Paper viewed from
inner side (opposite
to thermal-coating side)
SW95001B
Cut line
Paper
feed
direction
25 mm
Black mark size 5 x 9 mm
75 mm
25 mm
9.1 mm
Punched hole 5 mm
Preprinting not
recommended
within this zone