Zebra Technologies 7030 Printer User Manual


 
Programming
Cut And Present Commands
50
P1003636-002 TTP 7030™ Technical Manual 10/05/2009
Cut And Present Commands
Effects a paper cut-off and an eject through the presenter module. The RS command
automatically gives the eject length of 50 mm in addition to the factor stored in parameter p47.
If the printout length is too short, paper-feed is added until the minimum printout length (set by
parameters 37 and 38) is reached, before execution of the Cut command.
You can also use <RS> together with the paper advance command:
<ESC>J<160><RS>
Gives a cut & eject after
the last text line.
Effects paper cut-off only.
Eject can be effected with the <ESC><FF><n> command (see Eject (run presenter)
on page 51).
To avoid thin strips of paper in the printer, multiple cut commands without paper feed in-
between will not be performed. If the printout length is too short, paper-feed is added until the
minimum printout length is reached, before execution of the cut command.
See Also Note on cut position for the <RS> command above.
RS
Cut and Eject
1E Hex
30 Decimal
Note • The cut position is 17 mm before the print line. This makes the last 5 lines on a page
end up in the beginning of the next page. To get the cut after the text, Please set parameter 49
to auto.
ESC RS
Cut Only, no Eject
1B 1E Hex
27 30 Decimal
Note • Use the cut command if you want full control over the printer from your system. But
remember that you also must add commands to feed to the correct cut position and eject the
paper so that the customer can get hold of it.
Note • Top margin settings that moves the paper counts as paper feed.