Filter
Top Products
67
Programming
Logotypes
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Printing
To print a logotype you can use two commands, <ESC>L<n>, prints the logotype at the
current cursor position, just like any character. <ESC>g<n1><n2><n3><n4><n5> prints
the logotype at a specified X-Y position.
Erasing
All logotypes are erased with the <ESC>&L command.
n1 One byte logotype number, (0—15)
n2n3 Two byte X position measured in pixels from the left hand edge of the
print window.
n4n5 Two byte Y position in pixels from top of the page.
These bytes must always be inserted but they are ignored in variable-
page-length mode where logotypes are always printed at the current Y-
position.
Caution • Loading to the flash PROM will erase the RAM completely since the RAM is
used during the loading process. Any print data residing in RAM will thus be lost.