Default Parameter Settings
Print Setup
82
P1003636-002 TTP 7030™ Technical Manual 10/05/2009
Sets the function of the presenter. The Retract selections are only valid if a retract option is
fitted.
Sets the eject length of the printout, that is the length of paper that protrudes outside the printer
after a cut command. This eject length should be 40-63 mm. Marks on the test printout show
max and min eject length.
The default value when loading firmware is 40, but should be set individually from printer to
printer. The set value is shown in a line on the test printout.
After sending the command, store the parameters, and wait until the presenter motor buzzes.
Then make a self test printout to check if the set eject length is correct.
45
0Default
Presenter Mode
DRV
0 Min
230 Max
<ESC>&P<45><0> Eject page when new page is printed. (Retract disabled)
<ESC>&P<45><3> Eject page when new page is printed. Page not taken after 30s
will be retracted. (Range 1-30, 1 step = 10 s)
<ESC>&P<45><100> Retract page when new page is printed
<ESC>&P<45><103> Retract page when new page is printed. Page not taken after 30s
will be retracted. (Range 101-130, 1 step = 10 s)
<ESC>&P<45><200> Do nothing when new page is printed. (Auto-eject and retract
disabled).
<ESC>&P<45><203> Do nothing when new page is printed. Page not taken after 30s
will be retracted. (Range 201-230, 1 step = 10 s)
47
40 Default
Eject Calibration Constant
DRV
0 Min
255 Max
Example • This example sets parameter 47 to 50 and stores the parameters as default settings
<ESC>&P<47><50>
<ESC>&<4>