Filter
Top Products
P4T/RP4T
User Guide
17
Load the Media
Section Continues
P4T series printers are designed to print either continuous (journal)
media or label stock.
1. Open the Media Cover
Refer to Figure 7.1.
• Press the latch release button on the side of the printer as
shown at “1” below. The media cover will open automati-
cally
• Rotate the Media Cover back completely as shown exposing
the media compartment and the adjustable media supports.
2. Loading Media From An Internal Supply
Refer to Figure 7.2.
• Pull the media supports apart as shown.
• Insert the roll of media between them, and let the media sup-
ports close. Ensure that the media pulls off the core in the
direction shown in Figures 7.2 and 7.4. The supports will center
the media roll within the media compartment, and the media
roll should be able to spin freely on the supports.
Figure 7.1 Opening the Media Cover Figure 7.2 Loading the Media
Press down on the Media
Cover Latch Lever
Pull Media Supports
apart where shown.
Load Media Roll
Note direction media
pulls o the roll.
Media cover opens
Printer Preparation
pg. 7
Connecting the
Printer pg. 27
Radio Regulatory
Information pg. 31
RP4T Printers pg.
35
Maintenance pg. 36
Troubleshooting pg.
38
Specications pg.
43
Appendices pg. 46 Index pg. 52
P4T Overview-
pg. 5
Manual
Introduction pg. 4