Filter
Top Products
P4T/RP4T
User Guide
18
Figure 7.3- Loading Media From An External Supply
Section Continues
3. Loading Media From An External Supply
Refer to Figure 7.3. A P4T Series printer configured with the External Media
option has a loading slot in the rear of the media compartment allowing you to
use 4.0 in. (101.6 mm) wide fanfold or roll media from an external supply. The
external supply must be designed such that it does not exert excessive drag as
media is fed through the printer, which could result in distorted printing.
• Pull the media supports apart, insert a Media Spacer (Zebra part number
BA16625-1) between them, and let the media supports close.
• Insert the media from the external supply through the rear feed slot, between
the media guides and up through the media compartment as shown. Make
sure the side of the media you will be printing on faces the printhead.
Rear Feed Slot
Media Spacer
External Media
Source
Printer Preparation
pg. 7
Connecting the
Printer pg. 27
Radio Regulatory
Information pg. 31
RP4T Printers pg.
35
Maintenance pg. 36
Troubleshooting pg.
38
Specications pg.
43
Appendices pg. 46 Index pg. 52
P4T Overview-
pg. 5
Manual
Introduction pg. 4