Filter
Top Products
81
Printer Configuration and Adjustment
Adjust Printer Settings
4/8/14 ZT400 Series™ User Guide P1066582-002
Programming
Position
If the desired programming position (read/write position) is not achieved through RFID
tag calibration, a value may be specified. See the RFID Programming Guide 3 for more
information.
Accepted values:
F0 to Fxxx (where xxx is the label length in
millimeters or
999, whichever is less)
The printer feeds the label forward for the
specified distance and then begins
programming.
B0 to B30
The printer backfeeds the label for the
specified distance and then begins
programming. To account for the backfeed,
allow empty media liner to extend out of the
front of the printer when using a backward
programming position.
Related ZPL command(s):
^RS
SGD command used:
rfid.position.program
User menu item: RFID PROGRAM POS. on page 109
Printer web page: View and Modify Printer Settings > RFID Setup >
PROGRAM POSITION
RFID Antenna
Element
If the desired antenna is not achieved through RFID tag calibration, a value may be
specified.
Note • This parameter does not apply to ZD500R printers, which always use an
antenna element value of A1.
Accepted values:
A1, A2, A3, A4
B1, B2, B3, B4
C1, C2, C3, C4
D1, D2, D3, D4
E1, E2, E3, E4
Related ZPL command(s):
^RW
SGD command used:
rfid.reader_1.antenna_port
User menu item: RFID ANTENNA on page 109
Printer web page:
View and Modify Printer Settings > RFID Setup >
RFID ANTENNA
Table 4 • RFID Settings (Continued)