Filter
Top Products
Printer Configuration and Adjustment
Adjust Printer Settings
70
P1066582-002 ZT400 Series™ User Guide 4/8/14
Reprint
Mode
When reprint mode is enabled, you can reprint the last label printed by pressing and holding
PAUSE + CANCEL on the printer’s control panel.
Accepted values:
• ON
• OFF
Related ZPL command(s):
^JZ
SGD command used:
ezpl.reprint_mode
User menu item: REPRINT MODE on page 95
Printer web page: N/A
Maximum
Label Length
Set the maximum label length to a value that is at least 1.0 in. (25.4 mm) greater than the
actual label length plus the interlabel gap. If you set the value to one that is smaller than the
label length, the printer assumes that continuous media is loaded, and the printer cannot
calibrate.
For example, if the label length is 6.0 inches (152 mm) including the interlabel gap, set the
parameter for at least 7.0 inches (178 mm).
Accepted values:
0 to the maximum label length supported by the printer
Related ZPL command(s):
^ML
SGD command used: ezpl.label_length_max
User menu item:
LABEL LENGTH MAX on page 96
Printer web page: View and Modify Printer Settings > Media Setup >
Maximum Length
Table 1 • Print Settings (Continued)
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Set the maximum label length to approximately
this value
1
3