Hewlett-Packard R4.2 Manual

A SERVICE OF

next previous

4 Switch Interface Administration Digital Interfaces

UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 159

The Card Number: field is blank in Figure 90 on page 158. After you enter

the circuit card number, certain E1-only fields disappear (

Idle Code:, A-

LAW or MU-LAW:

, and CRC:).

3 Change any of the parameters as described in Assigning T1 A/B Robbed-

bit E&M to Digital Circuit Cards on page 151.

4 Press F3 (Save).

The system changes the protocol parameters on the selected circuit card.

Displaying T1 A/B

Robbed-bit E&M

Parameters

The circuit card must first be assigned to the T1 A/B Robbed-bit E&M

protocol to use this procedure. See Assigning T1 A/B Robbed-bit E&M to

Digital Circuit Cards on page 151 for more information about making the

initial assignment.

To display the T1 A/B Robbed-bit E&M parameters:

1 Start at the T1 A/B Robbed-bit E&M menu (Figure 88 on page 151) and

select:

> Display Parameters