A Summary of Commands start_vs
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 595
the start_vs command to start it again. The start_vs also should be used if
the system was rebooted or powered down after stop_vs was used.
The start_vs command checks to see if the user stopped the system with the
stop_vs command. The start_vs command places all cards placed in the
manual-out-of-service (MANOOS) state with the stop_vs command in the
in-service (INSERV) state.
You must be logged on to the system console as root to use the start_vs
command.
Since the /vs/data/spchconfig file cannot be edited while the voice system
processes are running, it is a good idea to check the value of nbufs in the
/vs/data/spchconfig file before executing the start_vs command. The value
of nbufs defines the number of speech buffers. For the voice system to
operate properly, nbufs must be set to 2.5 times the number of active
channels.
Example
The following example starts the voice system software:
start_vs
See Also
stop_vs
