4 Switch Interface Administration Digital Interfaces
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 161
The Card Number: field is blank in Figure 91. After you enter the circuit
card number, certain E1-only fields disappear (
Idle Code:, A-LAW or
MU-LAW:
, and CRC:).
The system displays the parameter values for the selected circuit card.
3 Press F6 (Cancel) to return to the T1 A/B Robbed-bit E&M menu.
Unassigning T1 A/B
Robbed-bit E&M to
Digital Circuit Cards
Note: Before attempting to make any assignment changes to circuit
cards, they must be in the MANOOS state. See Equipment State
on page 103 in Chapter 3, Voice System Administration , for
additional information.
If you also change digital protocol assignments on the voice
system, you must make the change on the switch.
To unassign the T1 A/B Robbed-bit E&M protocol to a digital circuit card:
1 Start at the T1 A/B Robbed-bit E&M menu (Figure 88 on page 151) and
select:
> Unassign Card
