NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 989
Night Connection - Fixed - CCIS N-15
Operating Procedure (cont’d)
3. Station C answers and is connected with the CO RT. If necessary, the call can be transferred to another
station by means of Call Transfer-All Calls service.
Service Conditions
1. Calls that are being processed, or are in the Hold state when the NIGHT mode is entered, will be
disconnected after the mode changeover has been completed.
2. If the NIGHT CONNECTION station to which an incoming call has been directed is busy, the calling
party will hear ringback tone until the station becomes idle.
3. This service feature may be provided with NIGHT CONNECTION-FLEXIBLE [N-2] and TRUNK
ANSWER FROM ANY STATION [T-8] in the same system.
4. If the NIGHT CONNECTION station is set for CALL FORWARDING-ALL CALLS [C-5], incoming
Central Office trunk calls terminated to that station will be forwarded to the designated station.
5. Incoming calls that will be routed to NIGHT CONNECTION stations are limited to Ring Down trunks.
6. Such calls programmed in the ALDN command should use LDN NIGHT CONNECTION - CCIS [L-29].
Programming
STEP 1: ACSI - Assign the Night Connection-Fixed station number to the route and trunk number.
RT=
, TK=
CSI=6 (Night Connection-Outside)
ADC=
STEP 2: ACFR - Release the call forwarding restriction by Night Connection Fixed (TSFI = 2).
STEP 3: ARSC - Release the incoming connection restriction of the route and station assigned in ACSI. (RRI =
0, 1)
STEP 4: ASPD - Assign Speed Dial number.
ATT
CO RT
[Node A]
CCIS
[Node B]
C
NIGHT MODE
PUBLIC
SWITCHED
TELEPHONE
NETWORK
