NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 935
Message Reminder - CCIS M-34
Operating Procedure (cont’d)
7. D
term
B presses the MSG key and receives ringback tone. Redial is automatically made to Station C and
Station C rings.
Service Conditions
1. A message can be sent out only when the called station is either idle or busy.
2. A message can be sent out during ringing, recall from Call Transfer-All Calls, or recall from Consultation
Hold-All Calls.
3. A maximum of four messages can be received at one D
term
. If the fifth message terminates, the LCD
displays:
4. A message is displayed only when the handset is resting on the switch hook.
5. To clear the message, display the message and press “#”/“
*
” on the key pad. (ASYD-SYS1 Index 80, Bit
1)
6. If the MSG key is reset, the message is cleared.
7. A message cannot be cleared by the message sender.
8. If the second message is sent out from the same D
term
, it is memorized as the second unique message.
9. If Call Transfer-All Calls service is set, a message is also transferred to the designated transfer destination.
10. Messages are memorized in any D
term
on which the feature key has been programmed as Message
Reminder key.
Programming
Setting by MSG key (D
term
)
STEP 1: ASYD - System Data 1, Index 80, Bit 1. Message Reminder service-key used for Message Deletion
(D
term
)
0/1: # key / * key
STEP 2: AKYD -AssigndatatoFeaturekey.
FKY = 6 (Message Reminder)
STEP 3: ASFC - With respect to SFC of the stations that sets Message Reminder service, cancel the restriction
of SFI = 53. (SFI = 53: Message Reminder service)
Setting by SHF + Access Code (Individual Station)
STEP 1: ASYD - System 1, Index 17, Bit 0. SHF + ACC Code during ringback tone.
N
E
C
NEC
D
term
(a)
[Node A]
[Node B]
D
term
(b)
CCIS
STN (c)
RBT
RBT
RG
MESSAGE BUSY
