NEC Electronics America 2400 PX Manual

A SERVICE OF

next previous

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1

Page 129

Call Forwarding - Don’tAnswer-D

term

C-3D

Programming (cont’d)

STEP 8: ACFO - For tenant-wide CALL FORWARDING-DON’T ANSWER-D

term

, assign CF = 2 for a

destination (CFI) of either the Attendant Console or a station.

FCCS Programming

This data setting describes only the additional or replacement commands used to activate FCCS

services. When used as an FCCS feature, these commands replace the non-network commands (for

example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending

on the node.

Note 1

STEP 1: ASYDL - This data must be assigned to the node set Call Forwarding service.

System Data 1, Index 640: Assign the Fusion Point Code (FPC) of the node providing the attendant

console.

Note 1: When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required

in addition to ASYDL or ASYDN.

Note 2: The data of the ASFC command is assigned to the node set Call Forwarding service.