NEAX2400 IPX Feature Programming Manual
Page 524 NDA-24297, Issue 1
M-48 Multi Channel Recording - DAT
Operating Procedure (cont’d)
b.) Dial the MULTI CHANNEL RECORDING (REPLAY) access code from the station; receive
special dial tone.
c.) Enter Route Number and Trunk Number; the special dial tone stops.
d.) A recorded message of the designated trunk is automatically played back.
e.) Replace the handset to finish playback of the recorded message.
Note: Even though recording of a message has been finished, playback of the trunk cannot be accepted until
dubbing of the message to the remaining trunks is complete.
3. Recording by designating RT (All trunks within the designated route are recorded.)
a.) Lift a handset; receive dial tone.
b.) Dial the MULTI CHANNEL RECORDING (RECORDING) access code from the station;
receive special dial tone.
c.) Enter Route Number and press #; the special dial tone stops.
REPLAY
(Time Display)
REPLAY
005 001
Route Trunk
REPLAY START
In 5 seconds
DDD 1
Replay Time
(Time Display)
REC
(Time Display)
REC
005
Route
