56 C
HAPTER
6: Q
UICK
S
ETUP
FOR
M
ANAGEMENT
A
CCESS
Connecting to an External Modem
To connect to and configure the external modem
port, follow these steps:
1
From the top level of the Administration Console,
enter:
system serialPort connectModem
You can now issue commands to the attached
modem that support whatever communication
parameters are appropriate to your installation. All
characters that you enter in the Administration
Console are transmitted to the modem port.
2
To break the connection, enter the escape sequence
~]
with no intervening characters.
When you enter the escape sequence, the connection
to the modem port is broken and you return to the
previous menu.
Configuring the IP Management Interface
These instructions include information on defining an
out-of-band IP management interface through which
you can manage your system.
In-band or Out-of-band Management?
If you manage your system and its attached LANs over
the same network that carries your regular data
traffic, then you are managing your system
in-band.
This kind of management is often the most
convenient and inexpensive way to access your
system. The disadvantage is that, if your data network
is faulty, you may not be able to diagnose the
problem because the management requests are sent
over the same troubled network.
If you are managing your system using a dedicated
network for management data, then you are
managing your network
out-of-band
.
In-band Management
To manage your network in-band, you need to set up
an IP routing interface. You can then choose to
manage in-band through a VLAN, or using a port. See
the
Command Reference Guide
for information on
how to set up an IP routing interface.