Filter
Top Products
Removing the 3C389 PC Card 2-5
Verify that you are using the correct STP connector. The
correct STP connector is labeled with the number 100.
6 Turn on the power to the PC.
Proceed to Chapter 3 for instructions on how to install
the network drivers.
Removing the 3C389 PC Card
Removing the cable from the 3C389 PC Card makes the
operating system behave as if the PC Card has been
physically removed from the slot. See Appendix C for
more information.
Follow these steps to remove the 3C389 PC Card:
1 Switch off the power to the PC.
2 With the cable still attached to the 3C389 PC Card,
remove the 3C389 PC Card from the PC.
3 To detach the cable from the 3C389 PC Card, retract
the latching button (the half-circle in the center of
the connector) by sliding it backwards away from
the 3C389 PC Card.
4 Disconnect the cable connector from the 3C389
PC Card.