Filter
Top Products
DOS ODI Hot-Pluggability and Suspend/Resume C-3
DOS ODI Hot-Pluggability and Suspend/Resume
It is recommended that you use the NetWare Event
Service Layer program (NESL.COM) for hot-plugging to
work in this environment. Without this support, you
should use the following procedure.
Complete the following procedure to remove the 3C389
PC Card or to go into a suspend mode:
1 Unload all the drivers.
Remove them in the reverse order they were installed. by
typing the following commands at the DOS prompt:
netx u (“or” vlm u)
ipxodi u
tokencs u
lsl u
2 Remove the card from your machine.
Once the card is removed, you can enter and exit
suspend mode as often as you like before reinstalling the
card. It is best to reinstall the card while the machine is
not in suspend mode.
After reinserting the card or resuming, you can restart
your network software by typing the following
commands at the DOS prompt:
lsl
tokencs
ipxodi
netx
DOS NDIS Hot-Pluggability
You can insert and remove your card before and after
using Windows for Workgroups. You cannot hot-plug the
card while using Windows for Workgroups. Insert the
card before starting the software. Remove the card only
after exiting the Windows for Workgroups environment.