Filter
Top Products
3-14 CHAPTER 3: INSTALLING THE NETWORK DRIVERS
14 Click OK when you get the message that the
CONFIG.SYS has been successfully updated.
15 Click Exit on the Exiting MPTS panel.
16 Shut down OS/2 and restart your PC to let the
changes take effect.
OS/2 NDIS 2 device driver using MPTS installation is
complete when the following conditions exist:
■ The device driver files load successfully and there are
no error messages.
■ You are able to log on and communicate with the
network.
If you experience problems, go to Chapter 5,
“Troubleshooting.”
IBM LAN Support Program/Native Installation
The LAN Support Program/Native (LSP Native) installs the
LAN support driver DXMCSMOD.EXE. It does not support
the NDIS environment and should not be used for the
installation of NDIS drivers.
Perform the following installation steps for the 3C389
PC Card when using DOS and LSP Native:
1 Insert TokenDisk diskette #2 into the floppy drive
and type:
a:\lspnativ\dxmaid [Enter]
The default configuration will install both the 3C389
PC Card driver for Native mode (DXMCSMOD.SYS) and
the NetBIOS interface (DXMT0MOD.SYS). DXMCSMOD is
a card-services-aware version of DXMC0MOD, the native
token ring driver that comes with the LAN Support
Program (LSP). A Card Services enabler is no longer
necessary to use LSP. DXMCSMOD.SYS supports Card
Services 2.1 and utilizes a parameter initialization file
called LSP.INI to read in configuration options. The LSP.INI
file is similar to the PROTOCOL.INI file that is used in the
NDIS environment.