Filter
Top Products
5-16 CHAPTER 5: TROUBLESHOOTING
Transmit Error Codes
If you experience time-out errors during the on-ring test,
try running the wrap test in the diagnostics. If the wrap
test is completed successfully, but the on-ring test fails, it
might indicate problems on the Token-Ring network that
the NIC is opening onto during the on-ring test.
For any other errors, ensure that the NIC and cabling are
properly connected, and retry the test. If the NIC
continues to fail, record the error and contact your
network administrator.
Table 5-6 Recommended Actions Key
Number Description
1 After delaying at least 30 seconds, retry the open two
times, inserting the same delay between each try.
2 After delaying at least 30 seconds, check the PC Card
configuration (especially the PC Card data rate) and
retry the open.
2a If this error persists, direct the computer operator to
contact the network administrator for assistance and
provide Open Error information.
2b If this error persists, direct the computer operator to
contact the network administrator for assistance.
3 Direct the computer operator to contact the network
administrator for assistance and provide Open Error
information.
4 Direct the computer operator to contact the network
administrator for assistance and provide Node Address
information, and try attaching to the ring after 6
minutes.
5 If this error persists, problem determination of the
PC Card or lobe is necessary. Contact your network
administrator for problem determination assistance.