Filter
Top Products
Installing and Operating the Module 3 - 3
4. Install the module into a blank slot in
the concentrator and tighten the
faceplate screws.
Installing the Module
5. Establish connections from the
Security Module to devices or a
10BASE-T transceiver using the
appropriate connectors and cabling.
Installing the Module
6. If you have a management module
installed in the concentrator,
configure the module using the
management commands.
Configuring the Module
7. Verify LED status for normal
operation.
Note: To resolve potential problems,
consult the troubleshooting
techniques in Chapter 5.
LED and Network
Verification
Table 3-1. Procedures for Completing Installation (Continued)
Step Procedure Reference