Filter
Top Products
4 - 8 ONline 10BASE-T Security Module Installation and Operation Guide
ONline> set security port 3.all action_on_intrusion disable_and_trap [ENTER]
The default setting for action_on_intrusion is disable_and_trap.
Note: For a security intrusion attempt to be logged into the
Intruder list, you must configure the action_on_intrusion
setting for either disable_and_trap or trap_only. Both
settings allow a trap to be sent upon an intrusion, which
also logs an entry into the Intruder list.
Configuring Autolearning Mask
Autolearning Mask:
❑ Allows or prevents a port's MAC addresses from being learned by the
EMM during Autolearning.
❑ Determines if the EMM is allowed or prevented from downloading
learned MAC addresses to the ports.
The Autolearn Mask command either allows (disable the mask) or prevents
(enable the mask) the EMM from learning or downloading MAC addresses
for ports.
Issue the following command to allow the EMM to learn MAC addresses
during Autolearning for all ports on the Security Module in slot 3.
ONline> set security autolearn 3.all mask disable [ENTER]
Enabling Ports
For an EMM to learn MAC addresses for ports through Autolearning, the
ports must be enabled (at some point) to allow network traffic to pass
through. Therefore, ensure that ports are enabled prior to initiating
Autolearning. Note that Autolearning will run on a disabled port, however,
no MAC addresses will be learned.