Filter
Top Products
3 - 12 ONline 10BASE-T Security Module Installation and Operation Guide
4. Remove the long screw (if present) from the 50-pin cable. Discard this
screw.
5. Remove the two cable-fastening screws from the Security Module
shipping carton.
6. Attach the 50-pin cable connector to the 50-pin connector on the
front of the module.
7. Install the two screws in the top and bottom screw holes of the
50-pin cable connector to secure the cable to the module connector
as shown in Figure 3-5. (Only one of the cable-fastening screws may
be installed depending on the angle of the 50-pin cable connector.)
Figure 3-5. ONline 10BASE-T Security Module Cable Connection
8. Attach the other end of the cable to a 10BASE-T Transceiver or a
10BASE-T Adapter Card.