Filter
Top Products
4 - 10 ONline 10BASE-T Security Module Installation and Operation Guide
4. The result of this copy is a combination of the existing MAC
addresses associated with a port, and the MAC addresses recently
learned. (Remember that a port must have its Autolearning Mask
disabled in order for MAC addresses to be learned.)
5. If MAC addresses for the specified ports currently exist in the
Autolearning database, the following message is displayed when the
Autolearn Capture command is issued:
Note: overwriting previously autolearned addresses.
If no MAC addresses were learned for the specified ports, then the
following message is displayed:
Autolearn capture done; learned 0 addresses total.
6. Upon completion of Autolearning, the following message is
displayed:
Autolearn capture done; learned x addresses total.
(where x indicates the total number of addresses now stored in the
Autolearning Database)
The stored MAC addresses are now ready to be downloaded to the
Security Module ports. Refer to the section, Downloading the Autolearning
Database, further in this chapter.
Note: Security Mode must be disabled in order for the EMM to
Autolearn MAC addresses for ports that are configured for
Security Types Intrusion_only or Full. If Security mode is not
disabled for each port that is configured for Intrusion
Security:
– MAC addresses will not be Autolearned
– The ports will report an intrusion