Filter
Top Products
3 - 18 ONline 10BASE-T Security Module Installation and Operation Guide
The following output is an example of the SHOW PORT ALL VERBOSE
command issued for the ports of a Security Module installed in slot 12 (only
the output for ports 1, 2, and 3 are shown):
ONline> show port 12.all verbose [ENTER]
Port Mode Status Network General Information
12.01 DISABLED LINK FAILURE ISOLATED
Port Alert Filter: DISABLED
Port Connector: TELCO
Link Integrity: ENABLED
12.02 DISABLED LINK FAILURE ISOLATED
Port Alert Filter: DISABLED
Port Connector: TELCO
Link Integrity: ENABLED
12.03 DISABLED LINK FAILURE ISOLATED
Port Alert Filter: DISABLED
Port Connector: TELCO
Link Integrity: ENABLED
Monitoring the Front Panel
The Security Module has 12 Activity and 12 Status LEDs on the front panel
that indicate the state of the ports. The LEDs allow you to monitor the
status of each port. The front panel also contains a Module Status indicator
that indicates the state of the module. Figure 3-5 shows the location the
LEDs. Each LED indicates the state of its port as described in Table 3-4.