Filter
Top Products
92 CHAPTER 3: MULTIFUNCTIONAL INTERFACE MODULES
MIM-1T1-F/MIM-2T1-F/MIM-4T1-F
1/2/4-port fractional T1 interface module (MIM-1/2/4T1-F) and MIM-1/2/4T1
module are different in the sense that:
■ FT1 operating mode supported by T1-F modules allows only one bundle. In
other words, the time slots can only be bundled into one nx64 kbps or 56 kbps
channel, where n=1-24. However, a CT1 module allows of arbitrary grouping
of the 24 channels;
■ T1-F does not support PRI mode.
n
Given a MIM-1T1 module, the system automatically creates a serial interface for
each timeslot bundle formed on a controller T1 interface.
Interface Attributes The interface attributes of MIM-1T1/MIM-2T1/MIM-4T1 and
MIM-1T1-F/MIM-2T1-F/MIM-4T1-F modules are given in the following table:
Interface LEDs MIM-1T1 panel is similar to that of MIM-1T1-F. The following figure shows a
MIM-1T1 panel.
Table 52 Interface attributes of MIM-1T1/MIM-2T1/MIM-4T1 and
MIM-1T1-F/MIM-2T1-F/MIM-4T1-F modules
Attribute Description
Connector RJ-45
Number of connectors 1 (MIM-1T1/MIM-1T1-F module)
2 (MIM-2T1/MIM-2T1-F module)
4 (MIM-4T1/MIM-4T1-F module)
Interface standard G.703/T1.102
G.704
AT&T TR 54016
AT&T TR 62411
ANSI T1.403
Interface rate 1.544 Mbps
Cable type T1 cable (100-ohm shielding network
cable)
Operating mode CT1, ISDN PRI
(MIM-1T1/MIM-2T1/MIM-4T1 module)
FT1
(MIM-1T1-F/MIM-2T1-F/MIM-4T1-F
module)
Supported service 1) Backup
2) Terminal access service
3) ISDN PRI
(MIM-1T1/MIM-2T1/MIM-4T1 module)