Filter
Top Products
Simple Network Management Protocol
11-6
11
Web – Click SNMP, Configuration. Enter the IP address and community string for
each management station that will receive trap messages, specify the UDP port,
SNMP trap version, trap security level (for v3 clients), trap inform settings (for v2c/v3
clients), and then click Add. Select the trap types required using the check boxes for
Authentication and Link-up/down traps, and then click Apply.
Figure 11-3 Configuring SNMP Trap Managers
CLI – This example adds a trap manager and enables authentication traps.
Configuring SNMPv3 Management Access
To configure SNMPv3 management access to the switch, follow these steps:
1. If you want to change the default engine ID, do so before configuring other
SNMP parameters.
2. Specify read and write access views for the switch MIB tree.
3. Configure SNMP user groups with the required security model (i.e., SNMP v1,
v2c or v3) and security level (i.e., authentication and privacy).
4. Assign SNMP users to groups, along with their specific authentication and
privacy passwords.
Console(config)#snmp-server host 10.1.19.23 private version 2c
udp-port 162 40-5
Console(config)#snmp-server enable traps authentication 40-7