Filter
Top Products
cluster member
61-3
61
Command Mode
Global Configuration
Command Usage
• An “internal” IP address pool is used to assign IP addresses to Member
switches in the cluster. Internal cluster IP addresses are in the form
10.x.x.member-ID. Only the base IP address of the pool needs to be set since
Member IDs can only be between 1 and 36.
• Set a Cluster IP Pool that does not conflict with addresses in the network IP
subnet. Cluster IP addresses are assigned to switches when they become
Members and are used for communication between Member switches and the
Commander
.
• You cannot change the cluster IP pool when the switch is currently in Commander
mode. Commander mode must first be disabled.
Example
cluster member
This command configures a Candidate switch as a cluster Member. Use the no form
to remove a Member switch from the cluster.
Syntax
cluster member mac-address <mac-address> id <member-id>
no cluster member id <member-id>
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch.
(Range: 1-36)
Default Setting
No Members
Command Mode
Global Configuration
Command Usage
• The maximum number of cluster Members is 36.
• The maximum number of switch Candidates is 100.
Example
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#