Filter
Top Products
Switch Cluster Commands
61-2
61
• Configured switch clusters are maintained across power resets and network
changes.
Example
cluster commander
This command enables the switch as a cluster Commander. Use the no form to
disable the switch as cluster Commander.
Syntax
[no] cluster commander
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• Once a switch has been configured to be a cluster Commander, it
automatically discovers other cluster-enabled switches in the network. These
“Candidate” switches only become cluster Members when manually selected
by the administrator through the management station.
• Cluster Member switches can be managed through only using a Telnet connection
to the Commander. From the Commander CLI prompt, use the rcommand id
command (see page 61-4) to connect to the Member switch.
Example
cluster ip-pool
This command sets the cluster IP address pool. Use the no form to reset to the
default address.
Syntax
cluster ip-pool <ip-address>
no cluster ip-pool
ip-address - The base IP address for IP addresses assigned to cluster
Members. The IP address must start 10.x.x.x.
Default Setting
10.254.254.1
Console(config)#cluster
Console(config)#
Console(config)#cluster commander
Console(config)#