Filter
Top Products
32-1
Chapter 32: CLI Command Groups
The system commands can be broken down into the functional groups shown below.
Table 32-1 Command Group Index
Command Group Description Page
General Basic commands for entering privileged access mode, restarting the
system, or quitting the CLI
33-1
System Management Display and setting of system information, basic modes of operation,
maximum frame size, and restarts the system
34-1
File Management Downloads or saves software code and system configuration files 35-1
Console Port and Telnet Configures console port and Telnet access settings 36-1
System Logging Configures system event logging 37-1
SMTP Alerts Sends alert mail messages based on system events 38-1
System Clock Configures SNTP and other time settings 39-1
Simple Network
Management Protocol
Activates authentication failure traps; configures community access
strings, and trap receivers
40-1
User Authentication Configures user names and passwords, logon access using local or
remote authentication, management access through the web server,
Telnet server and Secure Shell; as well as restricted access based on
specified IP addresses
41-1
Port Security Restricts port access based on source MAC addresses 42-1
IEEE 802.1X Configures IEEE 802.1X port access control 43-1
Access Control List Provides filtering for IPv4 frames (based on address, protocol, TCP/
UDP port number or TCP control code), IPv6 frames (based on
destination address, next header type, or flow label), or non-IP frames
(based on MAC address or Ethernet type)
44-1
Interface Configures the connection parameters for all Ethernet ports,
aggregated links, and VLANs
45-1
Link Aggregation Statically groups multiple ports into a single logical trunk; configures
Link Aggregation Control Protocol for port trunks
46-1
Broadcast Storm Control Configures a packet-rate threshold on ports to control broadcast
storms
47-1
Mirror Port Mirrors data to another port for analysis without affecting the data
passing through or the performance of the monitored port
48-1
Rate Limit Controls the maximum rate for traffic transmitted or received on a port 49-1
Address Table Configures the address table for filtering specified addresses, displays
current entries, clears the table, or sets the aging time
50-1
Spanning Tree Configures Spanning Tree settings for the switch 51-1
VLANs Configures VLAN settings, and defines port membership for VLAN
groups
52-1
Private VLANs Enables and configures private VLANs 53-1
Protocol VLANs Configures protocol-based VLANs 54-1