Filter
Top Products
System Utilities
97
Onboard USB
When enabled, you can connect USB devices to
the onboard USB port on the rear of the computer.
The default setting is Enabled.
Reset PnP Resources
The system resources are already properly
configured. If resource conflicts arise, you can set
this parameter to Yes to reset and reallocate PnP
resources, after which the BIOS automatically
resets this parameter to No, which is the default
setting.
Power Saving Options
Selecting Power Saving Options on the BIOS Utility
main screen presents a screen that allows you to
adjust several power-saving settings.
When Lid is Closed
The computer’s lid switch acts as its power switch:
opening the display wakes up the computer,
closing the display puts it to sleep. The When Lid
is Closed setting determines which suspend mode
the computer enters when the display is closed:
Suspend to Disk or Suspend to Memory. The
default is Suspend to Disk.
q Suspend to Disk. With this setting, the
computer saves all data to the hard disk
when you close the display. The computer
wakes up when you reopen the display.