Requirements For Your System
10 Megabit Modem 400F, 500L, 600F, and 700F User Manual
REQUIREMENTS FOR YOUR SYSTEM
You need the following hardware and software to complete the installation and configuration of
the Megabit Modem 400F, 500L, 600F, and 700F:
• PC with an Ethernet Network Interface Card (NIC)
• TCP/IP network protocol stack (see the operating system documentation)
• Web browser installed such as Netscape
®
or Internet Explorer
®
Version 4.0 or higher
• Ethernet hub (optional)
REQUIREMENTS FOR THE INSTALLATION SITE
Before installing the Megabit Modem 400F, 500L, 600F, and 700F, you must:
• select a location to install the modems as described in the section below
• identify requirements to connect phones as described in the section “Phone Service” on
page 13
Location for Modem Installation
You can install the modem either:
• placed on a flat surface (shown on page 11)
• mounted on a wall (shown on page 12)
Your facility must have the following minimum site requirements to install each modem:
• power outlet
• RJ-11 wall jack that has DMT ADSL service available