Filter
Top Products
Managing CMM Directory Content Managing Redundancy in a Stack
OmniSwitch 6600 Family Switch Management Guide March 2005 page 4-27
To synchronize the secondary CMM to the primary CMM, enter the following command at the prompt:
->copy flash-synchro
The copy flash-synchro command is described in detail in the OmniSwitch CLI Reference Guide.
Note. When synchronizing the primary and secondary CMMs, it is important to remember that the
boot.params file and the switch date and time are not automatically synchronized. See the OmniSwitch
6600 Family Getting Started Guide for information on the boot.params file, and Chapter 2, “Managing
System Files,” for information on setting the switch date and time. The date and time are synchronized
using the system time-and-date synchro command.
Synchronizing the System Date and Time
To synchronize the system date and time, use the system time-and-date synchro command. This
command synchronizes the secondary CMM date and time to the primary CMM date and time.
Enter the command as shown:
-> system time-and-date synchro