Filter
Top Products
SNMP Overview Using SNMP
page 10-14 OmniSwitch 6600 Family Switch Management Guide March 2005
18 bgpEstablished bgpPeerLastEr-
ror
bgpPeerState
bgp The BGP routing protocol has
entered the established state.
bgpPeerLastError—The last error code and subcode seen by this peer on this connection. If no error has
occurred, this field is zero. Otherwise, the first byte of this two byte OCTET STRING contains the error code,
and the second byte contains the subcode.
bgpPeerState—The BGP peer connection state.
Note: This trap is not supported on OmniSwitch 6600 Family switches.
19 bgpBackwardTransition bgpPeerLastEr-
ror
bgpPeerState
bgp This trap is generated when the
BGP router port has moved from
a more active to a less active
state.
bgpPeerLastError—The last error code and subcode seen by this peer on this connection. If no error has
occurred, this field is zero. Otherwise, the first byte of this two byte OCTET STRING contains the error code,
and the second byte contains the subcode.
bgpPeerState—The BGP peer connection state.
Note: This trap is not supported on OmniSwitch 6600 Family switches.
20 esmDrvTrapDropsLink esmPortSlot
esmPortIF
ifInErrors
ifOutErrors
esmDrvTrap-
Drops
interface This trap is sent when the Ether-
net code drops the link because
of excessive errors.
esmPortSlot—The physicalsSlot number for this Ethernet Port. The slot number has been added to be used by
the private trap.
esmPortIF—The on-board interface number for this Ethernet port. The port number has been added to be used
by the private trap.
ifInErrors—For packet-oriented interfaces, the number of inbound packets that contained errors preventing
them from being deliverable to a higher-layer protocol. For character-oriented or fixed-length interfaces, the
number of inbound transmission units that contained errors preventing them from being deliverable to a higher-
layer protocol. Discontinuities in the value of this counter can occur at re-initialization of the management sys-
tem, and at other times as indicated by the value of ifCounterDiscontinuityTime.
ifOutErrors—For packet-oriented interfaces, the number of outbound packets that could not be transmitted
because of errors. For character-oriented or fixed-length interfaces, the number of outbound transmission units
that could not be transmitted because of errors. Discontinuities in the value of this counter can occur at re-ini-
tialization of the management system, and at other times as indicated by the value of ifCounterDiscontinuity-
Time.
esmDrvTrapDrops— Partitioned port (separated due to errors).
21 pimNeighborLoss pimNeigh-
borIfIndex
ipmr Signifies the loss of adjacency
with a neighbor device. This trap
is generated when the neighbor
time expires and the switch has
no other neighbors on the same
interface with a lower IP address
than itself.
pimNeighborIfIndex—The value of ifIndex for the interface used to reach this PIM neighbor.
Note: This trap is not supported on OmniSwitch 6600 Family switches.
No. Trap Name Objects Family Description