Filter
Top Products
Using SNMP Verifying the SNMP Configuration
OmniSwitch 6600 Family Switch Management Guide March 2005 page 10-39
Verifying the SNMP Configuration
To display information about SNMP management stations, trap management, community strings, and
security, use the show commands listed in the following table.
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show snmp station Displays current SNMP station information including IP address, UDP
Port number, Enabled/Disabled status, SNMP version and user account
names.
show snmp community map Shows the local community strings database including status, commu-
nity string text and user account name.
show snmp security Displays current SNMP security status.
show snmp statistics Displays SNMP statistics. Each MIB object is listed along with its
status.
show snmp mib family Displays SNMP MIB information. Information includes MIP ID num-
ber, MIB table name, and command family.
show snmp trap replay Displays SNMP trap replay information. This includes the IP address of
the SNMP station manager that replayed each trap and the number of
the oldest replayed trap.
show snmp trap filter Displays the current SNMP trap filter status. This includes the IP
address of the SNMP station that recorded the traps and the identifica-
tion list for the traps being filtered.
show snmp authentication trap Displays the current authentication failure trap forwarding status (i.e.,
enable or disable).
show snmp trap config Displays SNMP trap information including trap ID numbers, trap
names, command families and absorption rate. This command also dis-
plays the Enabled/Disabled status of SNMP absorption and the Traps to
WebView service.