Filter
Top Products
Logging Into the Switch Using Secure Shell
OmniSwitch 6600 Family Switch Management Guide March 2005 page 1-13
To view the parameters of the Secure Shell session, issue the who command. The following will display.
-> who
Session number = 0
User name = (at login),
Access type = console,
Access port = Local,
IP address = 0.0.0.0,
Read-only domains = None,
Read-only families = ,
Read-Write domains = None,
Read-Write families = ,
End-User profile =
Session number = 1
User name = rrlogin1,
Access type = ssh,
Access port = NI,
IP address = 11.233.10.145,
Read-only domains = None,
Read-only families = ,
Read-Write domains = All ,
Read-Write families = ,
End-User profile =
This display shows two sessions currently running on the remote OmniSwitch at IP address
11.333.30.135. Session number 0 is identified as the console session. Session number 1 indicates the
User name is rrlogin1, the IP address is 11.233.10.145, and the Access type is “ssh” which indicates a
Secure Shell session.
Closing a Secure Shell Session
To terminate the Secure Shell session, issue the exit command. The following will display:
-> exit
Connection to 11.333.30.135 closed.
Using the example shown above, this display indicates the Secure Shell session between the two switches
is closed. At this point, the user is logged into the local OmniSwitch at IP address 11.233.10.145.
Log Into the Switch with Secure Shell FTP
To open a Secure Shell FTP session from a local OmniSwitch to a remote device, proceed as follows:
1 Log on to the OmniSwitch and issue the sftp CLI command. The command syntax requires you to
identify the IP address for the device to which you are connecting. The following command establishes a
Secure Shell FTP interface from the local OmniSwitch to IP address 10.222.30.125.
-> sftp 10.222.30.125
login as:
2 You must have a login and password that is recognized by the IP address you specify. When you enter
your login, the device you are logging in to will request your password as shown here.
-> sftp 10.222.30.125
login as: rrlogin2
rrlogin2's password for keyboard-interactive method: