Filter
Top Products
Verifying CLI Usage Using the CLI
page 5-24 OmniSwitch 6600 Family Switch Management Guide March 2005
4 Press the spacebar <sp> key to execute the filter option. The following will display.
Enter filter pattern: *vlan*
8193 dot1qBase vlan
8194 dot1qVlan vlan
8195 dot1qVlanCurrentTable vlan
8196 dot1qVlanStaticTable vlan
8197 vlanMgrVlanSet vlan
8198 vlanTable vlan
8199 vpaTable vlan
9217 vCustomRuleTable vlan
9218 vDhcpGenericRuleTable vlan
9219 vDhcpMacRuleTable vlan
More? [next screen <sp>*, next line <cr>*, filter pattern </>*, quit <q>]
The screen displays 10 table rows, each of which contain the text pattern “vlan” Alcatel’s CLI uses a
single level command hierarchy. (The screen rows shown above and below the table are not counted as
part of the 10 rows.) If you want to display the rows one line at a time, press Enter instead of the space bar
key. To exit the table, type the “q” character and the CLI will exit the more mode and return you to the
system prompt.
Verifying CLI Usage
To display information about CLI commands and the configuration status of your switch, use the show
commands listed here:
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. Additional information can also be found in “Using “Show” Commands” on page 5-4.
show session config Displays session manager configuration information (e.g., default
prompt, banner file name, inactivity timer).
show alias Lists all current commands defined by the use of the alias CLI com-
mand.
show prefix Shows the command prefix (if any) currently stored by the CLI. Prefixes
are stored for command families that support the prefix recognition fea-
ture.
show history Displays commands you have recently issued to the switch. The com-
mands are displayed in a numbered list.
show more Shows the enable status of the more mode along with the number of
lines specified for the screen display.