Filter
Top Products
AMD Confidential
User Manual September 12
h
, 2008
66 Chapter 7: Device Configuration
Interfaces
The Matrox G400 graphics device has both a PCI bus and an AGP bus connection, only
one of which can be used at any time to connect to PCI bus or AGP bus ports in other
devices.
Initialization and Reset State
Upon initial creation, this device initializes the internal registers to Matrox G400 standard
reset state, and creates a display window that acts as the VGA display. The Configuration
options are initialized to enable both the VGA and Matrox Power Graphics Mode. The
frame-buffer size is initialized to 32 Mbytes and the Bios File memory area is initialized
to all ones.
A reset will re-load the default PCI configuration registers and place default values in the
Chip and FIFO configuration for the Matrox G400 graphics device.
Contents of a BSD
The data saved in the BSD depends on the mode the graphics controller was in when the
BSD was saved. If the graphics controller was in VGA mode, the BSD file contains the
contents of all VGA registers, a copy of the 256-Kbyte VGA frame buffer, and all
configuration information. If the graphics controller was in Matrox Power Graphics
Mode (non-VGA in Windows) the linear frame buffer, Power Graphics registers, and PCI
configuration registers are saved in the BSD. When the BSD file is reloaded, all registers
and the frame buffer are restored, and a display image is captured and displayed in the
display window.
Configuration Options
Figure 7-10 shows the Information tab. The following information describes the active
configuration of the Matrox G400 graphics device.
The Graphics Hardware Model can be set to one of the following models:
Matrox Millennium G400 PCI
Matrox Millennium G400 AGP
Currently there is only support for the Matrox G400 chip with SingleHead feature
support available.
The Graphics BIOS version is the version of the BIOS that is assigned and used by the
graphics device. If you flash the BIOS the version number will change. For more
information about flashing the graphics device BIOS see Figure 7-11.
The Graphics Memory section shows information about the current memory
configuration of the graphics device. Currently supported memory configurations are:
32/16 MB SGRAM with 300 MHz RAMDAC
32/16 MB SDRAM with 300 MHz RAMDAC