Filter
Top Products
ThinkTank Manual
Your disk drives will whir and their lights will turn on
as your computer reads information from the disks. On the Ap-
ple II or IIe, you will soon see the ThinkTank date display
shown in Figure 2—4, which means that the program has loaded
successfully. Skip to Step 3.
Apple III. Before it loads the program, your com-
puter will display the message:
PUT PASCAL SYSTEM DISK IN BUILT—IN DRIVE. PRESS RETURN.
Remove the THINKTANK BOOT DISK from your built—in
disk drive (Drive 1) and replace it with the THINK—
TANK PROGRAM DISK. Then press RETURN. In a few sec-
onds you will see the date display; skip to Step 3.
(b)If power is on, reset your computer. Make sure you
have completed whatever program you were previously using.
Now simply press the BESET key (on some computers you may have
to press CTRL-~RESET). The program will start as described in
Step 2(a) above.
Figure 2—4: ThinkTank Date Display
— 16—